Note:
This is a real unusual inner cylinder see notes below.
You MUST have the Sheet METAL STRAP from the Bottom of the old inner cylinder to put on this new inner cylinder to make it work.
This Strap allowed the inner cylinder to set lower or in other words the out put shaft of the motor connected to the metal strap up in the inner cylinder. (Metal Strap is fasten on with 2 screws, the bottom and top metal ends are the same)

If you do not have the Strap then we will need to make you a
5-1/4" x 16" Inner Cylinder with Type "A" or Type "B" end
or
5" x 17" (a little shorter) with Type "A" or Type "B" end
NOTE: we will need to know what type motor your pole has to make the above inner cylinder or provide us the stamped number on the bottom of your inner cylinder (see below).

 

* Plastic Cylinder
* 5" Diameter X 16-1/2" Long
* Fits Koch and Paidar Poles Nos 95, 96, 195 & 196
* Must Re-Use strap from old lower end

If the Serial Number on your pole is above # 5500 it may be a type "A" motor. Prior to that they was type "B" motors

Note: the Koch/Paidar company used the last two digits of the year the pole was produced for the first two digits of the serial number for the pole.

Note: If the Inner Cylinder you presently have has a marking on the bottom of the metal end with "2A4" in it then this is the Plastic Inner Cylinder that will fit your Pole. Like: "2A4 ## ## "

*** MUST RE-USE METAL STRAP from LOWER END

If number on bottom of inner cylinder is "1A XX XX" then a inner cylinder will need to be custom made for you so please call us at 800-643-0333